Two types of design tests for relays and relay systems that relate to the immunity of this equipment to repetitive electrical transients are specified. Test generator characteristics, test wave-forms, selection of equipment terminals on which tests are to be conducted, test procedures, criteria for acceptance, and documentation of test results are described. This standard has been harmonized with IEC standards where consensus could be reached.
- Sponsor Committee
- PE/PSRCC - Power System Relaying and Control
Learn More - Status
- Superseded Standard
- PAR Approval
- 1995-03-16
- Superseded by
- C37.90.1-2012
- Superseding
- C37.90.1-1989
- Board Approval
- 2002-03-21
- History
-
- ANSI Approved:
- 2002-08-01
- Published:
- 2002-05-24
Additional Resources
- Erratas
- C37.90.1-2002_errata.zip
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More - Sponsor Committee
- PE/PSRCC - Power System Relaying and Control
Learn More - Working Group
-
C37.111_WG - Revision of PC37.111 Comtrade std.
Learn More - IEEE Program Manager
- Malia Zaman
Contact - Working Group Chair
- Mark Adamiak
No Active Projects
62843-2013
Standard for N times 64 kilobit per second optical fiber interfaces between teleprotection and multiplexer equipment
An optical interface for use between teleprotection and digital multiplexer equipment that can operate at a data rate of N times 64 kilobit per second where N = 1, 2u202612 is described. Requirements for both physical connection and the communications timing are also included.
C37.111-2013
IEEE/IEC International Standard - Measuring relays and protection equipment u2013 Part 24: Common format for transient data exchange (COMTRADE) for power systems
Also known as IEC 60255-24 Ed.2, this standard defines a format for files containing transient waveform and event data collected from power systems or power system models. The format is intended to provide an easily interpretable form for use in exchanging data. The standard is for files stored on currently used physical media such as portable external hard drives, USB drives, flash drives, CD, DVD. It is not a standard for transferring data files over communication networks.
C93.3-1995
American National Standard--Requirements for Power-Line Carrier Line Traps
This standard applies to a line trap inserted into a power circuit to minimize carrier-frequency signal losses. The standard covers line traps in which the main coil is designed as a single phase, air-cooled inductor of the dry type.
No Superseded Standards
No Inactive-Withdrawn Standards
No Inactive-Reserved Standards